Operation Manual LRB 20 000 LONG RANGE LASER RANGE FINDER BINOCULAR In USA: 3310 Prospect Ave. Cleveland, OH 44115 In Canad
7.5.2. To orient the range finder by using the reference directional angle, proceed as follows: - Binocular the range finder on the reference point
To make sure that the needle is free from defects, check that: - the needle oscillates in a smooth and uniform manner to regain balance; - the posi
- as the readiness indicator comes on, aim the range finder at an off-set point forward of the target; - as the target aligns with he reticle gap,
- - calculate from the determined magnetic azimuth Am of the reference point and the target to find the directional angles, reckoning in the compass
9. SERVICEABILITY TEST The principal tests to be performed on the range finder are listed below. Table 9.1 What is checked, tools, instruments
10.2. Maintenance Service Types and Intervals. 10.2.1. While in use, the range finder is subject to the following types of maintenance services:
Table 10.2 Operations Procedure as per Materials, tools and accessories 1. Servicing within check inspection scope 2. Cleaning
10.6.1. To clean the contacts in the battery section, do the following: - wind some cotton wool around one end of a wooden stick; - moisten the cott
11.2. The problems likely to occur in the range finder are listed with their causes and remedies below in Table 11.1
- protection device 12, used to supply the range finder with (27±2.7) V DC or 22-29 V from a vehicle electrical system, or with 22-29 V or 12-14.5 V
Features of the LRB 20 000 Laser Range Finder Binoculars • Digital Data Output • First or Last Target Indication • Built-in Compass • Light Weigh
This is provided by arranging the packing case so that the arrow marked on top points North. Charged batteries may be stored together with the range
- discharged by setting the toggle switches to the DISCHARGE and MAIN positions until the DISCHARGED light emitting diode flashes on and off to indic
16. DATA OUTPUT TO EXTERNAL EQUIPMENT The data on measured range is output to a remote display or computer across connector X2. To output the da
18. LONG TERM STORAGE CERTIFICATE Binoculars range finder LRB 20 000 AEP 36.28.001, Serial No. ___________________________ , has been pre
20. WARRANTY NEWCON OPTIK warrants this product against defects in material and workmanship for one year from the date of the original date of cons
Laser range finder binoculars LRB 20 000 1 - range finder; 2 - Angular Mount; 3 - tripod Fig. 1 Range finder (viewed on the side of eyepiece) 1 -
Angular Mount 1 - adjustment knob; 2 - lever; 3 - bracket; 4 - retainer; 5 - scale; 6 - framed lens; 7- adjustment knob; 8 - compass; 9 - nut
Individual SPTA set 1 - Rechargeable battery 10D-0,55С-1; 2 - fuse link VP1-1 1,0А 250 V; 3 - pencil; 4 - sealing ring; 5 - eye shield; 6 - framed
- inspect the range finder exterior for physical damage (no cracks, dents, deep rust are admitted); - check the dehydrator for working condition. I
2. PURPOSE 2.1. Binoculars range finder LRB 20 000 AEP 36.28.001 is a device of industrial-technical purpose and designed for ground surveillance, o
EMITTER: Ambient temperature Parameter –40˚ C normal conditions 50˚ C 1. Minimum operating pumping voltage U oper.min. , V, max 2. Maximum ope
Table 4.1, continued Description Designation Qnty Serial No. Remarks 19. C
Connector X1 couples the controls and the Rechargeable battery to control circuit board (A1). C1 and C2 are energy storage capacitors placed in t
6. SAFETY PRECAUTIONS 6.1. Range finder is an opto-electronic device emitting high-density pulses of dark light at wavelength of 1.06 µm, character
7. PREPARING FOR USE 7.1. Choose an observation post. 7.2. Rotate the objective frame to bring the reticle in sharp focus. 7.3. Check range finder f
Comments to this Manuals